This page last changed on Aug 08, 2013 by m_kija.

Hi everybody
I have a problem with "Push-button 2-gang plus with room temperature control unit "(MTN6212-4146 Schneider-Electric) I need to switch ON or OFF some of the channels on the "Switch actuator REG-K/12x230/10 with manual mode"(MTN649212 Schneider-Electric) when temperature in the room reach the desired temperature wich was set on the push-button like setpoint temperature...

Is this problem solvable? For programming the actuators I use ETS4...
Thanks in advance!
Best regards!

It should be possible to use rules for this. There are quite some examples on the forums.

Posted by mredeker at Aug 09, 2013 07:23
Document generated by Confluence on Jun 05, 2016 09:32