This page last changed on Jun 17, 2014 by jlevy.

Hi,

I need to be able to send a reset (DPT 1.015 - boolean) to devices on KNX. This requires using an individual address and not a group address. Is this doable? (this is temporary until some hardware is replaced...).

(also posted in Design forum... Sorry).

Thanks!

What do you mean with individual address?

Posted by mredeker at Jun 18, 2014 17:32

I mean an individual address as opposed to a group address. For example, one of the controllers has an address of 1.1.1. This is not a group address which typically has / in between the numbers.

The idea is to be able to send a DPT_Reset to the controller (1.1.1).

Posted by jlevy at Jun 18, 2014 18:24

Ok, you mean the physical address and we don't support this.

Posted by mredeker at Jun 18, 2014 22:42

Do you know if calimero supports this or how much work would it be to add it?

Posted by jlevy at Jun 19, 2014 03:56

I don't know. We don't use calimero anymore and wrote our own KNX stack.

Posted by mredeker at Jun 19, 2014 10:42

Thanks. Didn't know that.

Posted by jlevy at Jun 19, 2014 19:06
Document generated by Confluence on Jun 05, 2016 09:37