This page last changed on Jul 06, 2014 by klm129.

The command is an HTTP request.

I know it works since when I load in a browser it does control xbmc properly.

But when I added the command to a button push, after re-exporting files and refreshing the command did nothing. I dont have navigation connected to this button.

Here is the device command
Name: Right
Protocol: HTTP
Workload: "jsonrpc": "2.0", "method": "Input.Right", "id": 1
I know username and password are correct.

Rest are blank

Thanks in advance

Just found this error:
XMLHttpRequest cannot load No 'Access-Control-Allow-Origin' header is present on the requested resource. Origin 'http://localhost:8080' is therefore not allowed access.

Solved my own issue.

I just re-installed the controller and it worked.

Posted by klm129 at Jul 06, 2014 17:43
Document generated by Confluence on Jun 05, 2016 09:29