This page last changed on Nov 29, 2014 by subnetmask.

I've been trying to get the wattage sensor giving readings in OR, but so far I haven't had any luck figuring out what the HTTP command would be to send to the Razberry.

The closest I've gotten is with

, which got me
Uncaught TypeError: Cannot read property 'val' of undefined

What would be the commands to send to the Razberry to get the current wattage (and maybe kWh) readings, and possibly to reset the kWh meter?

Do use MeterLevel instead of SensorMultilevel. The parameters 0/0 as you specified should give kWh. 0/2 gives Watt

Hope this works for you. Works fine with my Fibaro wall plug, though I haven't got that working with the experimental UDP status push interface.

Posted by pz1 at Nov 29, 2014 08:26
Document generated by Confluence on Jun 05, 2016 09:39