This page last changed on Feb 12, 2011 by pjmm.

When using designer and   added a device it would be a big help if once you have added Telnet/Tcpip command

that the IP address and port are then the default for that device and do not have to be re entered each time a new

command is entered.

I have the following questions when testing new designs on iPhone besides poweing down the iPhone is there any way to have the phone load a new design? My iPhone loads the last device always even if it has changes.

On the iPhone under settings is ther any way to deleate old controlers?

In designer Would it be possable for Device to have the defolt IP and Port with the option to change if required in the command?

In designer would it be posable to have a copy option for Devices and Commands and when copying a device have the option to change its IP and Port

and have these changed in the commands attached to this device?

In Designer could the be an option for saving a device on its own and also have the facility to share devices?

Posted by pjmm at Feb 13, 2011 01:35

When using designer and added a device it would be a big help if once you have added Telnet/Tcpip command that the IP address and port are then the default for that device and do not have to be re entered each time a new command is entered.

Yes, agreed. This can be achieved with a low effort of remembering the last used parameter value (for the device) to medium-range effort of allowing/using configuration options per device in the designer to a larger effort where devices are stored as a data-structure and exchanged between designer and controller.

The low-effort would be something that is at least easy for someone to get started with by providing a patch.

Thanks for the feedback, Pierce.

– Juha

Posted by juha at Feb 13, 2011 06:28

On the iPhone under settings is ther any way to deleate old controlers?

Swipe sideways over the controller URL in the settings screen and a delete button should appear.

(yeah, not exactly obvious)

– Juha

Posted by juha at Feb 16, 2011 00:09

In designer Would it be possable for Device to have the defolt IP and Port with the option to change if required in the command?

In designer would it be posable to have a copy option for Devices and Commands and when copying a device have the option to change its IP and Port and have these changed in the commands attached to this device?

In Designer could the be an option for saving a device on its own and also have the facility to share devices?

All are very good suggestions, thanks. I'll add to the implementation list.

Posted by juha at Feb 16, 2011 00:17
Document generated by Confluence on Jun 05, 2016 09:30