This page last changed on May 23, 2010 by vidar007.

Any advice on which Ip router to choose for Iphone controlling my KNX system with the OpenRemote software?
Will the Eibmarkt be a good choice?
I appreciate your advice!

The eibmarkt one should work. You can find a list of supported devices here:

Posted by mredeker at May 24, 2010 09:17

Thanks, which of the listed devices would be recomended?
I have also found another one that might be usable: -> KNX IP BAOS 770

Posted by vidar007 at May 25, 2010 16:25

The new Siemens gateway is interesting also. It supports PoE and up to 4 simultan connections which is nice. Most of the current devices only support one connection.

Posted by mredeker at May 26, 2010 08:07

Thanks again, wich of the Siemens gateways do you mean?
I have also been recomended the Weinzierl one. Do you know if this supports more than one connection?

Posted by vidar007 at May 26, 2010 13:47

Info about the new Siemens devices: here

I don't know if the Weinzierl allows more than one connection.

Posted by mredeker at May 26, 2010 14:05

.. and both N 148/22 IP Interface and N 146/02 IP Router will work?

Posted by vidar007 at May 26, 2010 14:14

Yes, and if you don't want to use the router to connect more than 1 KNX line, the IP Interface is sufficient.

Posted by mredeker at May 26, 2010 14:26

Looking for a store.

Do you you if these are the new or old version?

Posted by vidar007 at May 27, 2010 11:02

The enertex one looks like the new one.

Posted by mredeker at May 27, 2010 11:10

Alright, so I finally have the new Siemens N 146/02 IP Router installed and connected to the KNX system.
The KNX system is also up and running, basically controlling lighting and heating, including scenarios etc.
I have also downloaded the full version of the OR KNX software.

The problem, or challenge, is programming the iphone. I can not find any nice tutorials on the website.
Is there any way I can import all the information about group adresses etc from the ETS library?

Where would you recomend beginners to start?


Posted by vidar007 at Aug 18, 2010 22:22

ETS import is not available yet.

You can look at the documentation on the OpenRemote website.

Posted by mredeker at Aug 19, 2010 08:03
Document generated by Confluence on Jun 05, 2016 09:30