This page last changed on Apr 03, 2013 by fichrist.

Hello,

I am trying to create a slider for my blinds using KNX protocol. I already created a slider for dimming lights, which works perfectly.
When I follow the same steps to setup the slider for the blinds, using two groupadresses 'value' and 'value status', the slider seems to work.
HOWEVER when I try to set the slider to 0%, nothing happens (problem does not occur for light dimming).
When I create a command of 0% directly on the bus via ETS, the blinds goes up completely, like it should. All KNX configuration of the blinds and the lights works similar on the bus.
Can anybody help me?

Thanks,
Filip

What console are you using?
Is this on iOS ?

I seem to have seen that issue with a KNX dimmer also but not with other protocols.

Posted by ebariaux at Apr 03, 2013 12:29

Yes, I use an Ipad.
I will test it with my android smartphone tonight.

Posted by fichrist at Apr 03, 2013 12:34

Hi,

I do have the same problem for my slider (blinds command), it is not working when setting 0%, but when setting 1% and others it works...
and all my dimmer sliders are working fine as well
my designs are on iphone and ipad

any idea ?

thanks
Franck

Posted by queuf at Apr 11, 2013 09:33
Document generated by Confluence on Jun 05, 2016 09:41