This page last changed on May 10, 2014 by jlevy.

Hi,

Trying to setup a KNX slider for a dimmer.

I've followed what I could figure out from http://www.openremote.org/pages/viewpage.action?pageId=19432285

My slider can set dimming fine but:

1. When I set it to 0 it does not turn the dimmer off. This is understood since it is not linked to the dimmer on/off address. How can this be added?
2. When I turn the dimmer on or off using another button for just on/off (0/100%) - the slider doesn't reflect the right level.

What I used for the slider is the Absolute dimmer (percentage) - 1 byte for the write and the Dimmer status which is also percentage with 1 byte.

Any ideas?

Thanks,
Yosi.

Document generated by Confluence on Jun 05, 2016 09:37