This page last changed on Sep 23, 2014 by nokk3r1.

In newest developer edition controller(2014-09-04) the range sensors doesn't work. Custom sensors work fine. I don't actively use level sensors so don't know about those. I'm using openremote to control KNX so it affects at least to that protocol. In earlier builds range sensors work fine.

Same with 2014-10-29 developer edition. Although it is much faster than older versions, but lack of range sensors renders it useless. Anyone else having similar issue?

Posted by nokk3r1 at Dec 17, 2014 06:19

Also, when looking into knx log there is lot of messages and mostly they are from status commands. Like following:

WARN 2014-12-16 23:07:38,831 (KNX): Unknown KNX property '<property name = "name" value = "PH ReadSetpoint"/>'.
INFO 2014-12-16 23:07:38,831 (KNX): Created KNX Command FRAME L_Data.req 0.0.0 -> 1/7/1 Data: 0x00 for group address '1/7/1'
WARN 2014-12-16 23:07:38,832 (KNX): Unknown KNX property '<property name = "name" value = "MH1 temp"/>'.
INFO 2014-12-16 23:07:38,832 (KNX): Created KNX Command FRAME L_Data.req 0.0.0 -> 1/3/0 Data: 0x00 for group address '1/3/0'
WARN 2014-12-16 23:07:38,845 (KNX): Unknown KNX property '<property name = "name" value = "KHH Status"/>'.
INFO 2014-12-16 23:07:38,846 (KNX): Created KNX Command FRAME L_Data.req 0.0.0 -> 1/6/3 Data: 0x00 for group address '1/6/3'
WARN 2014-12-16 23:07:38,847 (KNX): Unknown KNX property '<property name = "name" value = "KHH ReadSetpoint"/>'.
INFO 2014-12-16 23:07:38,847 (KNX): Created KNX Command FRAME L_Data.req 0.0.0 -> 1/6/1 Data: 0x00 for group address '1/6/1'

Still, some of which have generated message above, works just fine. For example "KHH status" listed above, but that is switch sensor. Also, there is similar messages generated by older version which work fine.

Posted by nokk3r1 at Dec 17, 2014 07:38

Ok. Figured where is problem:

In sensor log there is:

WARN 2014-12-23 21:57:36,475 : Sensor 'KHH setpoint sensor' (ID = 1,898,441) is RANGE type but produced a value that is not an integer : '27.0'

Is there fix for it?

Posted by nokk3r1 at Dec 23, 2014 20:03
Document generated by Confluence on Jun 05, 2016 09:31