This page last changed on Nov 19, 2013 by mgalper.

Hi everyone, I've been struggling with more or less the same issue mentioned in this topic:

http://www.openremote.org/display/forums/Prebuilt+designer

Using OpenRemote with a TCP/IP sensor, I can switch on and off correctly a lightbulb of my own, but when I want to obtain the temperature of a temp-sensor I have, my TCP/IP command lack of a \n at the end of it, or so I figured out after a lot of tests.

So is there any official way to do it, like 'tempcheck\n' implemented?

Because on the previous topic it was discussed, and implemented on trial, but no on the 'Preview Modeler'. If it is still not possible, there's no other way I could obtain my temperature I guess.

Thanks in advance,

Miguel

Document generated by Confluence on Jun 05, 2016 09:39