This page last changed on Sep 05, 2014 by tonygair.

I have created my Z-Wave network with a raspberry pi and a Aeons Z2 usb stick connecting two tkb switches (also relays) to Stella Z valves throughout a house. All these devices and switches have now successfully appeared in my openremote designer pro web application.

I have produced my navigation menus on an android device and am now looking at how to wire this up (figuratively speaking) to the android interface so that information is displayed and changes can be made to each valve.

These Stella Z devices have information such as current temperature, battery status , mode type such as "frost protection", "energy saving", "comfort". These are reported and some are set.

Is there a guide for connecting up these to a UI? I've seen the "creating navigation for openremote" video

Is there a UI widget template for the stella Z does anyone know?

(I mistakedly previously posted this in the design forum)

There are some templates on the pro designer but nothing especially for the Stella.

Posted by mredeker at Sep 06, 2014 21:05

Is there any instructions on sending commands (with parameters) to z wave devices do you know?
thanks

Posted by tonygair at Sep 08, 2014 10:46

There is something here: http://www.openremote.org/display/docs/Designer+2.0+-+Available+Z-Wave+Commands
I tested to set a setpoint with the Danfoss thermostat which worked.

Posted by mredeker at Sep 09, 2014 08:32

Thanks Again Marcus, can I ask for a screenshot of the actual command window in the designer or the exact command used to set the Danfoss Valves?

Posted by tonygair at Sep 09, 2014 09:45
Document generated by Confluence on Jun 05, 2016 09:39