This page last changed on Jul 27, 2014 by jonathan.wallis.

As this is my first post, I would first like to say hi to everyone.

I've followed the installation guides available and have been through the process of configuring open remote to use a Z-stick.

I've gotten to the point where I would view the Z-wave log in order to see the Nod ID's but the log file is showing blank. I'm not sure if the Openremote is starting the Z wave service.

Any guidance would be appreciated.

Hi Jonathan,

did you add Z-Wave nodes by means of the Aeon Z-Stick inclusion button ? I ask this to make sure that there are nodes in the Z-Wave network. Moreover, you could describe your serial port configuration of the Z-Wave USB stick in OpenRemote Designer.

Posted by rhitz at Aug 06, 2014 06:37

Hi Rainer

Thahnks for the reply. I've managed to resolve this issue by deleting the OZWlog and zwcfg_0x0184cdd8.xml and restarting the applicaiton.

I am however having a problem with the an issue at the following link:

http://www.opensourceautomation.com/phpBB3/viewtopic.php?f=12&t=1098

Posted by jonathan.wallis at Aug 06, 2014 07:27
Document generated by Confluence on Jun 05, 2016 09:39