This page last changed on May 23, 2015 by pierre2302.

Hello,

I have a concern with the webview, my internet box does not support the Loopback so if I put the local I can see the address webview only locally and if I put the address wan I can only see the outside. In contrast to the commands I enter the local url and no concern internally and externally.

I guess the commands run in-house unlike the webview which are loaded on the webconsole.

Can we by-pass this problem of loopback for webview ?

Thank you

I would suggest to change your internet box with the one that supports loopback, this makes a life easier.

Anyway, the only solution that works for me it to use ipv6 global addresses and forget about ipv4 limitations and nuisances.

Posted by aktur at May 23, 2015 12:32

Thank you for your reply

You say use IPV6 with this method is it still necessary to change the box ?

Posted by pierre2302 at May 23, 2015 20:19

No, it isn't.

Posted by aktur at May 23, 2015 21:02

Thank you very much

I go tried

Posted by pierre2302 at May 27, 2015 21:30
Document generated by Confluence on Jun 05, 2016 09:34