This page last changed on Oct 21, 2015 by wuytens.

Hi all,

i have a very strange issue.

i have a sensor in openremote that listens to the address 1/1/1 (example)

but i also have a command that writes to address 1/1/1

rule "init"
timer(int: 10s)
then
execute.command( "Muziek Bureau Status off" );
......
end

rule "Muziek Bureau on" when
Event( source == "Muziek Bureau Status" , value=="on")
then
execute.command( "Muziek Bureau scene","2");
end

i want to have the init because each time i reboot my openremote openremote tries to read all the sensors that i have causing bus load.

thx for helping me out

So, the real problem is that when Openremote boots it tries to pool all your KNX sensors causing the bus overload? Correct me if I misunderstood.

Posted by aktur at Oct 21, 2015 15:54

Michal,

that is correct.

so there are options to solve that problem. Let openremote write values to knx.

But there the second problem arises. When you write to the knx bus the openremote sensor does not change.

so if you write from openremote Music on and you have a sensor Music status then Music status is not updated if you execute the command Music on

Posted by wuytens at Oct 23, 2015 08:37
Document generated by Confluence on Jun 05, 2016 09:33