This page last changed on May 14, 2015 by gdhiraj2015.

Hello,

I managed to make slider pass on the dimmer value to lightwaverf dimmer, however i have 2 issues as follows -

(1) once i refresh the IOS contrller page the slider goes back to lowest state - is there a way to retain its status where it was left from last command ?

(2) the lowest position of slider doesnt activate the command - means if i slide the slides to far left then it doesnt activate the set dimmer command (which i use to pass on the slide INT value to "${param}"

any help ?

Document generated by Confluence on Jun 05, 2016 09:34